This patch harness gets fitted inside the vehicle just above the drivers side kick panel and provides a 12 volt output whenever the vehicles high beam headlights are activated.
No cutting of the factory wiring is required, simply unplug the existing factory connector and fit the patch harness between the factory connectors and then connect the output connector to your existing wiring harness.
This patch harness is also compatible with the D-Max, MU-X and BT-50 models that have factory LED headlights, including the new facelift MY24 D-Max and facelift MY25 MU-X models.
A complete system including:
Optional audio input to AUX factory head unit
Fits on the end of a M12 male four pin connector
With a large 1/3 inch colour SONY® CCD sensor providing sharper and higher detail in all light conditions, than standard 1/4 inch colour CMOS sensor cameras.
Easy installation as only one small four pin moulded connector (7mm diameter) four meters in length is required to pass through the firewall.
All exposed connections are all within the vehicle (video, power, mirror image and guidelines options) not in the extreme environment of the engine bay or under the rear of the vehicle.
Changing image from forward or reverse facing or adding guidelines is just a matter of cutting small, looped wires that are also located within the vehicle.
Input voltage is fully regulated to ensure a stable video signal across different input voltages and is again located within the vehicle.
Reviews
There are no reviews yet.