M12 4Pin aviation male connector to Isuzu/Mazda reverse camera connector, connects to the six pin camera connector that was within the tailgate, suits MY21 onwards.
Ideal for when removing the tub and fitting a tray, this adaptor allows for a plug and play solution when adding our CCD170HDG camera that have guidelines incorporated within the camera or CCD170HD camera (without guidelines).
This patch harness gets fitted inside the vehicle just above the drivers side kick panel and provides a 12 volt output whenever the vehicles high beam headlights are activated.
No cutting of the factory wiring is required, simply unplug the existing factory connector and fit the patch harness between the factory connectors and then connect the output connector to your existing wiring harness.
This patch harness is also compatible with the D-Max and BT-50 models that have factory LED headlights.
This camera is ideally suited for vertically mounting on the back of a caravan.
With a large 1/3 inch colour SONY® CCD sensor providing sharper and higher detail in all light conditions, than standard smaller 1/4 inch colour CMOS sensor cameras.
Features
Ultra low light capability (auto switching to IR at 0Lux (18 IR LEDs)
High resolution
SONY® CCD image quality
Built in microphone
IP68 fully encapsulated electronics
Reverse mountable
Horizontal viewing angel of 120°
Fully regulated power supply
Housing construction die cast zinc alloy (black powder coated).
With a large 1/3 inch colour SONY® CCD sensor providing sharper and higher detail in all light conditions, than standard 1/4 inch colour CMOS sensor cameras.
Features
Ultra low light capability
High resolution
SONY® CCD image quality
IP68 fully encapsulated electronics
Forward or reverse mountable (mirror image changeable)
Guide lines changeable
Wide horizontal viewing angel (two models to choose from 150°and 170° )
Fully regulated power supply
Bracket adjustable / removable.
Easy installation as only one small four pin moulded connector (7mm diameter) four meters in length is required to pass through the firewall.
All exposed connections are all within the vehicle (video, power, mirror image and guidelines options) not in the extreme environment of the engine bay or under the rear of the vehicle.
Changing image from forward or reverse facing or adding guidelines is just a matter of cutting small, looped wires that are also located within the vehicle.
Input voltage is fully regulated to ensure a stable video signal across different input voltages and is again located within the vehicle.
Made from POM material (chemically known as Polyoxymethylene) has a high mechanical strength and rigidity suitable for removing a range plastic trim and radio fascia’s.
Reviews
There are no reviews yet.